Quantcast

asctec-users

This is the Ascending Technologies User Group Mailing list. An online community for users of the Pelican and Hummingbird quadrotor helicopters.

Mailing List Options
Click "Options > Subscribe via email" to subscribe to this mailing list;
Click "Options > Post by email..." to get the email address of this mailing list;
You can post messages via email or through the forum interface below;
All web posts and emails are archived here.
1234 ... 9
Topics (311)
Replies Last Post Views
PC and HLP, UART rate can be 1KHz ? by _madcc
0
by _madcc
how to automatic run my program after system start up. by _madcc
0
by _madcc
no demo for communication between HLP and mastermind? by _madcc
2
by _madcc
AScTec SDK 3.0 installation on D:\ instead of C:\ hard disk by Karima
5
by tarek
Replacement blades for Firefly by ivan Mondragon
0
by ivan Mondragon
how to debug HLP without eclipse by _madcc
0
by _madcc
Teleop asctec pelican using mav_tools by Max
0
by Max
How to send external commands to the ESCs by Luczia
0
by Luczia
ACI Connection Problem by dishmaster
1
by Daniel D
the pins of HLP Jtag by _madcc
3
by _madcc
the version of HLP firmware by _madcc
1
by andre@asctec
autopilot control UNI software can't communicate with LLP serial 0 by _madcc
3
by _madcc
Vehicle Center by djanthony
1
by andre@asctec
the type of power connector of Pelican by _madcc
2
by _madcc
enquiry about AscTec product suppliers in Hong Kong / Mainland China / Taiwan by amiltonwong
2
by amiltonwong
Can't connect with JTAG by Giacomo
1
by andre@asctec
Connecting a Hokuyo UTM-30LX to Asctec Firefly by Eli
2
by andre@asctec
Enabling serial interface to HLP without Futaba by Sam
1
by andre@asctec
Asctec_autopilot problem by JaMora
2
by Lucas Proenca
[Emergency] Cannot turn on the Autopilot board by ChangSuHa
6
by nlpurnhyun
Pelican connection with ground pc by FrancisChoi
1
by Andreas
How to see if the UAV has reached a waypoint by daniel@asctec
1
by Carter Schultz
Xbee Simulink communication problem with Hummingbird by firiondel
0
by firiondel
Cannot get asctec_mav_framework working on atomboard/pelican by gdh
1
by gdh
Issue on using ethzasl_sensor_fusion with HighLevel_EKF mode by Luczia
1
by Luczia
Issue on sending mav_ctrl commands through ROS on pelican by Luczia
4
by Luczia
GPS doesn't lock by Carms
0
by Carms
DC voltage supply for gimbal and laser range finder by lemarshall
0
by lemarshall
Individual Motor Control by nsydney
2
by Jang, J. T.
Error: jtag.c:1253 jtag_examine_chain(): JTAG communication failure, check connection, JTAG interface, target power etc. by inam
6
by tarek
asctec hl interface: dynamic reconfigure problem by rocklinsuv
1
by rocklinsuv
Problem running OpenOCD in Eclipse by dishmaster
1
by MarkusAchtelik
asctec_mav_framework cmake problems by Silvan
2
by Silvan
asctec_hl_interface: cannot launch/locate hl_node by Daniel
7
by MarkusAchtelik
asctec hl interface: motor not starting (SOLVED) by rocklinsuv
1
by rocklinsuv
1234 ... 9